Mount Emitter with Tape Overview

Ubi Support -

Mounting emitter with tape is a temporary solution. It will not provide you the best interaction experience and it might damage the wall surface when removing. Please mount emitter with the screws if you decide to setup Ubi permanently.

Below is an overview of the steps for mounting emitter with tape. Please always follow the in-app setup instruction, which will provide more accurate and relevant instruction base on your setup.

For Ubi Emitter Unit V2

  1. Put protection tape on surface.
  2. Paste emitter base plate on protection tape.
  3. Snap emitter unit on the base plate.
  4. Adjust the emitter angle by using the three knobs.
  5. Verify the setup and interact.

For Ubi Emitter v1

  1. Put protection tape on surface.
  2. Paste emitter on protection tape and markers on corners.
  3. Power up emitter and adjust the emitter so it is parallel to the surface.
  4. Secure the emitter at the finale position (by wedge a piece of paper).
  5. Verify the setup and interact.

A complete instruction is here:http://forum.ubi-interactive.com/hc/en-us/articles/209598706-Mount-emitter-with-tape. 

 

 

Have more questions? Submit a request